GfA Elektromaten Door Control TS 971 Version 1000mA with CEE 3N~400V (5 pole)
€455.00
Product information "GfA Elektromaten Door Control TS 971 Version 1000mA with CEE 3N~400V (5 pole)"
Door control unit for GfA Elektromaten drives with digital or mechanical limit switch, automatic or constant pressure to close operation, with integrated radio system, variant with higher power, power supply for external devices up to 1000mA (24 V DC)
Description:
The door control unit TS 971 by GfA Elektromaten is an automatic control panel for use with GfA Elektromaten drives with digital (DES) or mechanical (NES) limit switch system. The TS 971 control panel comes with an integrated radio receiver for 434 MHz radio products of different manufacturers. In addition, the TS 971 has an integrated receiver, that can be used for the wireless transmission of the door safety edge in combination with the optional WSD module.
Properties:
- Protection class IP54 with CEE plug or IP65 for direct wiring
- Integrated push button for UP-STOP-CLOSE commands
- Integrated radio receiver for 434 MHz wireless products
- Parameter setting via selector switch with digital display
- Two independent, programmable relay contact, e.g. for red-green traffic-lights
- Operating modes: hold-to-run or self-hold/ automatic mode
- Automatic detection of safety edge type (Optical edge FRABA VITECTOR, resistive edge 8k2 or NC-contact type 1k2 with testing)
- Automatic timer-to-close
- Adjustable intermediate open position, e.g. half open, venting position
- Automatic ground adjustment (only DES) to compensate for rope-stretch or subsequent change in ground height
Due to the pre-assembled, pluggable motor cable, the TS 971 can easily be connected to the drive. A faulty wiring is hereby avoided, thus minimizing installation errors and time. The connection cable can be wired into the control panel housing from either top or bottom. In addition to the motor cable, the TS 971 can work with a multitude of additional inputs, e.g. rope-switches, photo eyes, sensing edges and many more.
The TS 971 by GfA Elektromaten comes with the function "radio/ wireless" already integrated, the control panel has an integrated receiver for remotes from different manufacturers using a frequency of 434 MHz. An additional radio receiver is not needed. In addition the wireless sensing edge transmission system WSD is already integrated on the control panel side. The WSD system is a wireless transmission system for sensing edges and allows monitoring and transmission of the most common sensing edge types, as well as pedestrian door and rope tension switches. The use of a coil cord is no longer needed. Of course the TS 971 also allows for connection with a coil cord.
The TS 971 has comfort functions and allows installation in more demanding applications. For standard-applications GfA Elektromaten offers the panel type TS970.
Login
Accessories
Electrical box with status LED, 40 x 136 x 56 mm, incl. 3x M16 cable glands, 1x M16 cable gland with bend protection and 4x M16 lock nutDescription:The Fraba Vitector large junction box is useful wherever lots of space is needed for cabling from sensors, photo-eye switches, pass-door switches, slack-rope switches, etc. The connection circuit board ensures the cables can be easily connected to the door.Further characteristics:Dimensions: 40 x 136 x 56 mmTransparent coverPre-punched cable entries 5xM16 in the housing, 1xM16 in the lidIncludes 3xM16 cable glands, 1x bend protector and 4 x locknuts
Set Transmitter (Tx) and Receiver (Rx) for Optical Sensing Edge OSE, PVC-cable, cable length 6,5m/0,5m, with Molex-plugsDescription:The FRABA VITECTOR OSE-S 6601 sensor set consists of a transmitter (Tx) and a receiver (Rx) for optical sensing edges. For an electrical connection, the sensors are equipped with a top-quality PVC Cable (length: transmitter - 6.5 m and receiver - 0.5 m) and pre-assembled GfA plugs. The sensors are based on the original FRABA OSE technology and provide the well-known OSE-signal, which is implemented in many controllers.Warning:The 4-digit sequence of numbers used on the displays shows the sensor's manufacture date in week / year format. For example, 0118 shows the sensor was produced in the first calendar week (01) of 2018.
Assembly kit emergency STOP switch for GfA Elektromaten door controls type TS, for installation in small cover
Assembly kit key switch for GfA Elektromaten door controls type TS, for installation in small cover, supplied with 2 keys
Assembly kit toggle switch for intermediate open position for GfA Elektromaten door controls type TS, for installation in small cover
Cable set for optical sensing edges OSE, includes coil cord 4x0,25 mm², cable ends 2,0m/ 0,35m, max. extension length 3,5m, with junction box and connection PCBDescription:The cable set for optical sensing edges consists of:- Pluggable 4-core coil cord, straight cable ends 2,0m/ 0,35m length, can be extended to a max. length of 3,5m - pre-assembled plug for connecting to GfA Elektromaten door control units- IP65 junction box with plug-in connector for OSE transmitter / receiver as well as pass-door and slack-door switches.
Separate connection kit for GfA Elektromaten door controls type TS, for direct wiring
Motor cable for GfA Elektromaten drives with digital limit switch DES, length 5m
Accessory for GfA Elektromaten controls type TS, for use with smartphone or tablet PC together with the "GfA+" App, for reading out and displaying of important data from the door control (e.g. programming, stored error logs, etc.)
Keypad Cover for GfA Elektromaten controls type TS, for preventing unintentional pressing of keypad buttons (e.g. for use in underground car parks), increased protection against direct contact with water
Separate connection kit for GfA Elektromaten door controls type TS, with mains switch/ isolator 1N~230V
Separate connection kit for GfA Elektromaten door controls type TS, with mains switch/ isolator 3N~400V
GfA Elektromaten polarized reflex photo cell (type: SICK WT280-S230) with reflector and mounting bracket, range 7,5m, protection class IP65, voltage 24 V DC with 1,5m UBS connection cable
Midi radio transmitter SKX1LC by GfA Elektromaten, 1-channel, 434 MHz, coded via dip-switch, includes 12V battery, status LEDDescription:GfA Elektromaten SKX1LC Midi radio transmitter.Technical characteristics:434 MHzcoded via dip-switchincludes 12V batteryLED status display
Midi radio transmitter SKX2LC by GfA Elektromaten, 2-channel, 434 MHz, coded via dip-switch, includes 12V battery, status LEDDescription:GfA Elektromaten SKX2LC Midi radio transmitter.Technical characteristics:434 MHzcoded via dip-switchincludes 12V batteryLED status display
Midi radio transmitter SKX4LC by GfA Elektromaten, 4-channel, 434 MHz, coded via dip-switch, includes 12V battery, status LEDDescription:GfA Elektromaten SKX4LC Midi radio transmitter.Technical characteristics:434 MHzcoded via dip-switchincludes 12V batteryLED status display
Wireless transmission system for sensing edges, pedestrian door switches and cable tension switches, works in combination with the GfA Elektromaten door control unit TS971. Frequency 2,4 GHz, in IP65 rated enclosure, incl. Battery
Key-switch in wall-mount aluminium enclosure, IP55 rating, 2-sided impulse switch, up/ down function, with cylinder lock and 3 keysDescription:Key-switch in wall-mount aluminium housing IP55 ratingimpulse switchwith cylinder lock and 3 keysavailable in various designs
Pull-switch with spring-supported rope, rope length 2,5m with rubber ball at the end, IP67 rating, with 3 cable entry openings M20x1,5, special switch design allows installation on the wall or ceiling without a need for additional installation equipmentDescription:The pull switch is ideal for ceiling or wall installationsIP 67 protection ratingIncludes 2.5m cord
reflective photo eye, max. range 9m, supply voltage 24 ... 240 V AC/ 12 ... 240 V DC, signal output: changeover relay, IP67 rated, 2m connection cableDescription:Universal Reflective Photo-eye barrier for contactless protection of industrial doors. The light barrier works on an extremely wide supply voltage range and through the execution of the output signal as a changeover relay (Normally Closed Contact and Normally Open Contact), it is compatible with most door control units.The photo-eye sensor works with visible red lights (630nm wavelength) and has a built-in polarisation filter. Through this, the photo-eye sensor is extremely impervious to external light and is easy to install.Coverage up to 9mUniversal power supply voltage AC 24 to 240V, DC 12 to 220V2m connection leadRelay output (changeover)
Coil cord for doors, EstTPU/PP, black, cable configuration: fine-stranded 5x0,25mm², Lif9Y11Y, dimensions: left end = 300mm, coil length = 900mm, right end = 2000mm, max. extension length 3,5m Description: The coil cord was developed especially for use on doors to connect the sensors and switches on the door leaf. Properties: Due to the 800mm-long spiral block, the coil cable can be extended to a length of up to 3.5m. The 5-core cable installation and a 0.25mm² conductor cross-section means the helical cable has enough strands for e.g. the safety edge and slack-rope switches Sheath and core insulation made of high-grade materials Can be installed universally on doors from various manufacturers
The VTX2 remote control from doorautomation24 combines modern design and reliable performance in a compact format. Equipped with a robust plastic housing, the remote control offers excellent functionality and is the perfect choice for the control of various devices. The high-quality workmanship and strong radio parameters of the VTX ensure reliable and convenient use. The remote controls of the VTX series are compatible with the radio receiver VRX150 from doorautomation24 and the integrated radio receiver of the door control unit TS971 from GfA Elektromaten. The integration into the existing door control unit TS971 is simple and is explained step by step in the document available under ‘Download’. Important features: Design: Robust plastic housing for long-lasting use Compatibility: Fully compatible with the VRX150 receiver from doorautomation24 and the TS971 from GfA Elektromaten Range, coverage: Stable radio range of up to 150 metres Security: KeeLoq® rolling code for high security with 4,294,967,296 possible combinations User-friendly: powered by 2 standard CR2016 batteries (included) Important information for use with the TS971 from GfA Elektromaten: To teach the remote control to the door control unit, the remote control must be programmed using the corresponding parameter of the door control unit. To do this, the installer must have access to the control unit programming.
Other customers also bought
Cable set for optical sensing edges OSE, includes coil cord 4x0,25 mm², cable ends 2,0m/ 0,35m, max. extension length 3,5m, with junction box and connection PCBDescription:The cable set for optical sensing edges consists of:- Pluggable 4-core coil cord, straight cable ends 2,0m/ 0,35m length, can be extended to a max. length of 3,5m - pre-assembled plug for connecting to GfA Elektromaten door control units- IP65 junction box with plug-in connector for OSE transmitter / receiver as well as pass-door and slack-door switches.
Replacement PCB for TS971 by GfA Elektromaten, delivery includes cover and keypad, universal replacement part for all versions/ covercolours of TS971Description:The Circuit Board TS971 by GfA Elektromaten is an original replacement parts for replacing defect electronics of the door control unit TS971. The TS971 replacement board can universally be used for all manufacturing years and models/ housing colours of the TS971.The replacement board comes as a pre-assembled unit including cover and push-buttons, as shown on the pictures above. Your benefits at doorautomation24:free technical support by phone100% original parts by GfA ElektromatenFast order processing and shipping*Shipping fee within EU, to Switzerland and Norway only 9,90 EUR*For orders and payments received before 14:00 from Monday through Friday we usually dispatch your goods on the same working day.
Midi radio transmitter SKX1LC by GfA Elektromaten, 1-channel, 434 MHz, coded via dip-switch, includes 12V battery, status LEDDescription:GfA Elektromaten SKX1LC Midi radio transmitter.Technical characteristics:434 MHzcoded via dip-switchincludes 12V batteryLED status display
Wireless transmission system for sensing edges, pedestrian door switches and cable tension switches, works in combination with the GfA Elektromaten door control unit TS971. Frequency 2,4 GHz, in IP65 rated enclosure, incl. Battery
The VTX2 remote control from doorautomation24 combines modern design and reliable performance in a compact format. Equipped with a robust plastic housing, the remote control offers excellent functionality and is the perfect choice for the control of various devices. The high-quality workmanship and strong radio parameters of the VTX ensure reliable and convenient use. The remote controls of the VTX series are compatible with the radio receiver VRX150 from doorautomation24 and the integrated radio receiver of the door control unit TS971 from GfA Elektromaten. The integration into the existing door control unit TS971 is simple and is explained step by step in the document available under ‘Download’. Important features: Design: Robust plastic housing for long-lasting use Compatibility: Fully compatible with the VRX150 receiver from doorautomation24 and the TS971 from GfA Elektromaten Range, coverage: Stable radio range of up to 150 metres Security: KeeLoq® rolling code for high security with 4,294,967,296 possible combinations User-friendly: powered by 2 standard CR2016 batteries (included) Important information for use with the TS971 from GfA Elektromaten: To teach the remote control to the door control unit, the remote control must be programmed using the corresponding parameter of the door control unit. To do this, the installer must have access to the control unit programming.
Spare parts
Bottom section for GfA Elektromaten control units TS959, TS970 and TS971, for installation of the TS board
Cover set for GfA Elektromaten control units TS959, TS970 and TS971, set consists of small and large cover part
Replacement PCB for TS971 by GfA Elektromaten, delivery includes cover and keypad, universal replacement part for all versions/ covercolours of TS971Description:The Circuit Board TS971 by GfA Elektromaten is an original replacement parts for replacing defect electronics of the door control unit TS971. The TS971 replacement board can universally be used for all manufacturing years and models/ housing colours of the TS971.The replacement board comes as a pre-assembled unit including cover and push-buttons, as shown on the pictures above. Your benefits at doorautomation24:free technical support by phone100% original parts by GfA ElektromatenFast order processing and shipping*Shipping fee within EU, to Switzerland and Norway only 9,90 EUR*For orders and payments received before 14:00 from Monday through Friday we usually dispatch your goods on the same working day.